Gypsum Board Troubleshooting

Many of the advantages of using gypsum board, especially when compared with ordinary plaster walls. Moreover, gypsum board does not require elaborate workmanship.

Maintenance and repair of gypsum was easier and cheaper. In addition, the lightweight gypsum board, and even resistant to fire.

Use ceiling gypsum can also minimize heat so the room will feel much cooler. In fact, gypsum boards are also available in these types of wet areas for bathrooms and other damp spaces.

Wet gypsum board area has a wax coating. Indirect water seep into gypsum. However, the installation process you need to pay attention to some things that are not problematic. Here are some tips for you in dealing with issues related to the installation and maintenance of gypsum:


Connection gypsum board too tightly

Actually, it does not sound so bad. However, two gypsum boards side by side and too tightly can break at any time. Because, one day, gypsum board which you can expand and grow. For that, given the distance of about 0.3 cm between the boards.

The connection is not strong

Avoid connection "hanging". For that, do the planning before you build. Connection "hang" only allowed, if you put a long sheet of gypsum board horizontally. Even then only be "hung" boards along the 40.6 cm. The rest, you're in trouble.

Too much sand

In order to obtain a smooth surface, a lot of people too much sand gypsum. If this happens, you certainly gypsum board will be damaged. Make sure you always check the sanding process by highlighting the gypsum board with a flashlight from the bottom of the board (low angle). In this way, the part that will soon appear uneven.

Fixing a perforated gypsum board

For minor damage gypsum boards, make sure the holes are clean. Brush to clean and dispose of all the particles out of the hole. Once clean, moisturise.

Use tape to patch. With a putty knife, a hole can be filled with gypsum or compound of choice. Once dry, sandpaper surface has been patched. Ensure flush with the surrounding area.

For large holes, you have to cut part of the gypsum wallboard little deeper. The damaged section was cut with a knife. Then, unloading pieces using a prybar.

However, you have to be careful when picking up and put new plasterboard. We recommend that you turn off the power first to prevent a short circuit. Cover section of gypsum board that has been cut with a piece of gypsum that had been prepared.

Next, provide kompoun the barrier layer and the periphery of gypsum cement and gypsum cement is pressed so that the surface flush with the surrounding area. Allow to dry. After that, then you should sand the boundary area between the gypsum to make it look neat.

More about → Gypsum Board Troubleshooting

"House Attack", Energy-efficient House

Strabag headquarters in the capital of Slovakia, Bratislava, built since 2005. The building is actually the first of three buildings planned buildings.

With a floor area of 12,500 square meters, office space is enough to accommodate 530 people. In addition, the building also has a parking space that can accommodate 450 cars.

The main topic of this building planning process is the concept of energy in it. Heating and air conditioning is supplied by geothermal investigations of groundwater connected to the pump-pump water heaters. Energy is not only distributed in the building.

Concrete roof slabs into the main heating and cooling in the building. However, if the temperature reaches a certain level, around minus 15 degrees, for example, then it should be no heating in the floor area of ​​the facade.

However, despite these heaters require additional energy, adding that occur throughout the year is still relatively small. The lion's share comes from the depth of 120 meters below surface. Because naturally, the energy use of this building is environmentally friendly energy.

Strabag Slovaki headquarters in Bratislava was designed by a company from Vietnam, the MHM Architects. Previously, the company has been looking for ways to reflect performance and interest in the company Strabag.

MHM Architects displays an extensive art collection Strabag. One of the most interesting views is "House Attack" by Erwin Wurm. "House Attack" is enough for a house occupied by a family. This little house is "dependent" on the corner of the building such as reverse will fall.

MHM focusing on ways to reduce energy use. Therefore, they use green glass of various shades for use in the building. Glass will provide sunlight and reduces outside noise pollution without sacrificing sunlight.

In addition, the sleek-shaped building also allows natural air flow. Garden on the roof will provide space for relaxation and can also be used for various events.

More about → "House Attack", Energy-efficient House

How a Good Kitchen Layout?

In the kitchen there are elements of water and fire, if the two elements balance, it would result in good luck and harmony.

How a Good Kitchen Layout? We know that, the kitchen serves as an activity area residents to produce something that can be consumed by a family member. If the room is treated properly, the kitchen will bring prosperity as well.
In the science of feng shui, the kitchen has a very important role. If you put a good place, residents will have good luck. But if not, disease and a waste of money as a result.

Therefore, the kitchen should still have full functionality. Thus, the expectation of the formation of space, financial and wealth of the occupants can easily get into the house.

To get a good kitchen, there are a few things to note:
• To help the occupants, the kitchen should not round shapes or irregular
• The kitchen floor should be level with the dining room floor
• The two-story house, the bathroom should not be above the kitchen
• The kitchen must have light and air vents (ventilation) is good
• The kitchen should not be in the middle of the house

From the description of the points above, may be useful for you who want to build a house or renovate the kitchen. Good luck.

More about → How a Good Kitchen Layout?